make sure that the high-voltage
battery unit is fully charged.
Check the state of charge
at regular intervals. Oth-
erwise, excessive discharge can
damage the high-voltage battery
unit.
Do not leave the vehicle
out of use for longer than
14 days with electric range down
to less than 10 km. If it is to
be out of use for up to three
months, if possible leave the
vehicle connected to a suitable
electricity supply or with the
high-voltage battery unit almost
fully charged.
Clean the E-Scooter.
Fully charge the high-voltage
battery unit.
Charge the 12V battery.
Spray the brake-lever, side-
stand and centre-stand pivot
mounts with a suitable lubric-
ant.
Coat bright metal and chrome-
plated parts with an acid-free
grease (e.g. Vaseline).
Stand the vehicle in a dry room
in such a way that there is no
load on either wheel.
Protective wax coating
BMW Motorrad recommends
applying only BMW car wax or
products containing carnauba
wax or synthetic wax.
It is time to rewax the paint-
work when water "puddles" on
the surface, instead of forming
beads.
Restore the E-Scooter
to use
Remove the protective wax
coating.
Clean the E-Scooter.
Charge the 12V battery.
Fully charge the high-voltage
battery unit.
Before starting: work through
the checklist.
11
110
z
Care
To Next Page
Loading...
