Installing fuse
Replace the defective fuse with
a fuse of the correct amperage
rating.
The fuse assignments and
fuse amperage ratings spe-
cified for your motorcycle are lis-
ted in the section entitled "Tech-
nical data". The figures in the
graphic correspond to the fuse
numbers.
Close the fuse cover.
The latch engages with an
audible click.
Installing side panel ( 99).
Installing 12V battery
Slip the 12V battery into the
battery holder.
Position the retainer on the
12V battery.
Install screw 3.
Installation in the wrong
sequence increases the risk
of short-circuits.
Always proceed in the correct
sequence.
Hold the positive battery cable
in position and install screw 2.
Hold the negative battery cable
in position and install screw 1.
Installing side panel ( 99).
Body panels
Removing side panel
The procedure for the left
side panel is described
here, but the description applies
by analogy to the right side panel
as well.
Open flap 1.
Remove screws 2.
9
98
z
Maintenance
To Next Page
Loading...
