Rims and tyres
Checking rims
Make sure the ground is level
and firm and place the E-
Scooter on its stand.
Visually inspect the rims for
defects.
Have damaged rims checked
and, if necessary, replaced by
an authorised BMW Motorrad
dealer.
Checking tyre tread depth
Your E-Scooter's handling
and grip can be impaired
even before the tyres wear to
the minimum tyre tread depth
permitted by law.
Have the tyres changed in good
time before they wear to the
minimum permissible tread
depth.
Make sure the ground is level
and firm and place the E-
Scooter on its stand.
Measure the tyre tread depth
in the main tread grooves with
wear marks.
Wear indicators are built
into the main profile
grooves on each tyre. The tyre
is worn out when the tyre tread
has worn down to the level of
the marks. The locations of the
marks are indicated on the edge
of the tyre, e.g. by the letters TI,
TWI or by an arrow.
If the tyre tread is worn to min-
imum:
Replace tyre or tyres, as applic-
able.
Tyre recommendation
For each size of tyre,
BMW Motorrad tests and
classifies as roadworthy certain
makes. BMW Motorrad cannot
assess the suitability or provide
any guarantee of road safety for
other tyres.
BMW Motorrad recommends
using only tyres tested by
BMW Motorrad.
You can obtain detailed informa-
tion on the Internet at
www.bmw-motorrad.com
or from your authorised
BMW Motorrad dealer.
Lighting
Replacing bulbs for low-
beam and high-beam
headlight
Switch off operational readi-
ness.
Removing side panel ( 98).
Remove the right side panel to
replace the bulb for the low-
beam headlight.
Remove the left side panel to
replace the bulb for the high-
beam headlight.
9
94
z
Maintenance
To Next Page
Loading...
