The automatic riding light
control system cannot re-
place your personal assessment
of lighting conditions. The sensor
cannot detect fog or drizzle, for
example.
In such situations the low beam
headlight must be switched on
manually, as otherwise a safety
risk would occur.
Repeatedly short-press but-
ton 1 until symbol 2 for the
automatic daytime riding light
appears.
Short-press button 3 to switch
on the automatic daytime riding
light.
Option indicator 4 is high-
lighted.
appears on the display.
When ambient brightness
drops below a certain value,
the low-beam headlight is
automatically switched on (e. g.
in a tunnel). When sufficient
ambient brightness is detected,
the daytime riding light is
switched back on. When the
daytime riding light is active,
the daytime riding light symbol
is displayed in the multifunction
display.
Short-press button 3 to switch
off the automatic daytime riding
light.
Option indicator 4 is not high-
lighted.
Manual operation of the
light when the automatic
system is switched on
If you press the button for the
daytime riding light, the daytime
riding light is switched off and
the low-beam headlight and front
side lights are switched on (e. g.
when you ride into a tunnel, and
the response of the automatic
daytime riding light to the change
in ambient brightness is delayed).
If you press the button again the
daytime riding light is reactivated,
in other words the daytime riding
light is switched on again when
ambient light is bright enough.
Parking lights
Switch off operational readi-
ness ( 38).
4
47
z
Operation
To Next Page
Loading...
