BOC Smootharc Multi 180 - Electrical Shock Prevention; Electromagnetic Field Awareness; User Responsibility in Operation

7BOC Smootharc Multi 180/200 Operating manual
Electrical shock
→ Never touch ‘live’ electrical parts.
→ Always repair or replace worn or damagedparts.
→ Disconnect power source before performingany maintenance
orservice.
→ Earth all work materials.
→ Never work in moist or damp areas.
→ Wear dry insulated boots.
→ Wear dry leather gloves.
→ Work on a dry insulated oor where possible.
Electromagnetic eld
This power source may cause electrical or electromagnetic elds to
be produced which could a󹟽ect the correct functioning of electronic
equipment such as IT or CNC devices, telecommunication lines, power
cables, signal lines and pacemakers.
User responsibility
→ Read the Operating Manual prior to installation of this machine.
→ Unauthorised repairs to this equipment may endanger the technician
and operator and will void your warranty. Only qualied personnel
approved by BOC should perform repairs.
→ Always disconnect mains power before investigating
equipmentmalfunctions.
→ Parts that are broken, damaged, missing or worn should be
replacedimmediately.
→ Equipment should be cleaned periodically.
BOC stock a huge range of personal protective equipment. This combined
with BOC’s extensive retail network ensures fast, reliable service
throughout the South Pacic.
STOP
Under no circumstances should any equipment or parts be
altered or changed in any way from the standard specication
without written permission given by BOC. To do so, will void
the EquipmentWarranty.
Further information can be obtained from Weld Australia (WTIA)
Technical Note No.7.
Health and Safety Welding
Published by WTIA,
PO Box 6165 Silverwater NSW 2128
Phone (02) 9748 4443