10.0 General Cleaning
The interior of the printer should be cleaned whenever there is a visible accumulation of dust. Use a small
vacuum for cleaning. Be careful not to jar any of the printer’s parts loose.
11.0 Logic Board
The printed circuit boards used in this product have been manufactured using surface mount technology.
These printed circuit boards cannot be effectively repaired in the field and should be returned to the
manufacturer if repair is required.
Warning: ALL SERVICE SHOULD BE DONE WITH POWER OFF AND THE AC CORD
UNPLUGGED FROM THE PRINTER.
See below pictures for main logic board access: (Click on printer name for larger picture)
Lemur & Lemur-K (metal) Lemur-S (metal cabinet) Lemur-2
(Electronics cover removed) (Rear panel removed) (Electronics cover removed)
Lemur-S (plastic cabinet) Lemur-2P
(Access panel removed) (Access panel removed)
Lemur & Lemur-K (Plastic)
(Electronics cover removed)
To Next Page
Loading...
