5.0 Ticket Load Procedure
Turn the printer on and wait five seconds. The red CHECK PAPER led will be illuminated (if your printer has
an optional LCD then it will display PAPER OUT). Begin loading the tickets through the entrance slot with a
smooth motion until the ticket stock comes to a stop (at this point the stock is between the thermal head and
platen). Keep pressure against the stock and the printer will automatically feed the ticket stock.
NOTE: see Appendix C for loading of Lemur-2 and Lemur-2K printers.
Above two photos are of a Lemur and Lemur-K printer. The ticket feed area of a Lemur-2 and Lemur-2K
would look the same.
Above photo is of a plastic cabinet Lemur-S with optional cutter and cover removed. Your printer may vary.
Load your stock towards this
side and below this metal plate
The black timing mark on the back of your ticket stock
should past over this side facing down towards the opto
Reverse Adjustable (RADJW & RADJ4)
The black timing mark on the back of your ticket stock should
pass over this side facing down towards the opto
Load your stock towards this
side and below this metal plate
Adjustable (ADJ4, ADJW & ADJ2)
To Next Page
Loading...
