To Next PageTo Next Page
Need help?Do you have a question about the Bodet Sigma C and is the answer not in the manual?
General| Model | Sigma C |
|---|---|
| Display | LCD |
| Storage Temperature | -20°C to +70°C |
| Connectivity | Ethernet |
| Power Supply | 230V AC |
| Power Consumption | 5W |
| Operating Temperature | +50°C |
| Clock Synchronization | NTP, DCF |
| Compatibility | Bodet clocks |
Mains supply, circuit breakers, cable routing, and backup recommendations.
Terminal connections for wall version and RJ45 connector LED status.
Rack unit connector accessibility at the rear.
Steps for configuring DHF time distribution, including transmission power and channel.
Steps for programming RHF circuits, including relay assignment and INIT mode.
Explanation of the purpose and function of each key on the keypad.
A visual flowchart illustrating the programming options and navigation.
How to access and navigate the user menu, including access code entry.
Loading or backing up programming data via a USB flash drive.
Step-by-step instructions to load a program from a USB drive.
Step-by-step instructions to save the current program to a USB drive.
Steps to change the time, date, and time zone of the master clock.
Steps to enter the time for a program step.
Defining step status as ON, OFF, or duration, and melody parameters.
Choosing days and modes (WEEKLY, HOLIDAYS, SPECIAL, PUBLIC HOLIDAYS).
Detailed steps for adding a new program step to a circuit.
Steps to delete all program steps for a selected circuit.
Procedure to enter the technician menu using a fixed access code.
List of main functions available in the technician menu.
Available modes for time synchronisation: DCF, GPS, NTP, Auto, NONE.
Detailed steps for defining the start dates for summer/winter time changeovers.
Viewing outputs, modifying status, and configuring DHF distribution in Init mode.
Steps to set IP address, subnet mask, and gateway for the master clock.
Mapping relays (D1D2, alarm) to specific outputs.
Configuring RHF circuits for melody or relay mode.
Defining external input allocation for master or slave (BACK-UP) modes.
Detailed procedure for updating the master clock firmware via a USB drive.
Steps to configure the master clock to act as an NTP server.
