Bodet Sigma C - Programming Management; Deleting All Programming; CPU Software Update

33
11.7 “Delete all programming” menu
This menu can be used to delete all the programming.
To go to this master clock menu, validate the option in the
technician menu with the key.
The following screen is displayed :
To delete, validate with the key.
11.8 CPU software download menu
This menu allows you to update the program code in Flash.
In the www.bodet-time.com/en/support.html, click on “Downloads”. Download the latest version
of the programs on your USB ash drive.
To go to this master clock menu, validate the option in the
technician menu with the key.
Follow these steps before proceeding to the rmware update:
1- The USB drive should contain only the update version of the rmware.
2- The USB ash drive should contain only the update version of the rmware.
3- Turn the power back on and proceed with the update.
4- The code le (*.cod) must be on the root of the USB ash drive and be the only “.cod” le.
Insert the USB key.
The following screen is displayed :
to download,
validate with the key.
The following screen is displayed :
validate with the key.
The Sigma may not restart if these steps are not followed and the CPU card will have to be
replaced.
A power failure during the update process will cause “System Failed” alarm. Again, the card
must be replaced.
Delete programing ok
Update syst. soft õ
Delete all prog:Yes ú
ok
Confirm delete ú
all programs ok
Update syst. soft ok
Factory config. õ
Connect USB key then
press ok exit C
Reading USB
in progress ......
Confirm syst. soft ok
update C
Transferring
Stage 01 ......