30
11.3 IP configuration menu
This menu is used to congure the IP parameters of the master clock.
To enter the master clock IP conguration menu, validate
the option in the technician menu with the key.
The following screen is displayed :
If DHCP
1
=YES, then it is the network’s DHCP server which
gives the product its IP parameters.
If you wish to give the Sigma C a xed address, validate this option (set to No) with the
key.
The following screen is displayed:
Enter the IP address and then validate.
The following screen is displayed:
Enter the sub-network mask and then validate.
The following screen is displayed:
Enter the address of the gateway and validate the option in
the technician menu with the key,
This data is neither saved nor present in the printing.
After validation, the master clock restarts automatically to take into account the DHCP
changes.
1 Dynamic Host Conguration Protocol (DHCP) is a term designating a network protocol which carries
out an automatic conguration of the IP parameters of a station, notably by automatically assigning it an
IP address and a sub-network mask.
IP setting ok
Relay setting õ
DHCP : No ú
IP Address fixed ok
IP Address : ú
---.---.---.--- ok
Subnet Mask ú
---.---.---.--- ok
Gateway : ú
---.---.---.--- ok
To Next Page
Loading...
Need help?
General