Bodet Sigma C - Circuit Program Management; Deleting Program Steps; Modifying Program Steps; Deleting Entire Circuit Programs

23
8.4.2 Delete a program step
1/ Select the number of the circuit you wish to delete a
program step using the key.
2/ Select the PROG mode with the and
validate with the key.
3/ Select the program step to be deleted with the key.
4/ Select the EFF mode and validate.
8.4.3 Modify a program step
1/ Select the number of the circuit you wish to modify a program step using the key.
2/ Select the PROG mode with the and validate
with the key.
3/ Select the program step to be modied with the key.
4/ Modify and validate.
8.5 Deleting a program
1/ Select the number of the circuit you wish to delete using
the key.
2/ Select DELETE mode with the and keys and
validate with the key.
After validation, all the steps of the program are deleted.
8.6 Viewing the status of a circuit
1/ Select the number of the circuit which you wish to view the status of by pressing the
key.
2/ Select STATUS mode with the and keys and
validate with the key.
You will see the theoretical status of the programming
circuit: ON, OFF, FORCED ON (if the circuit is forced
manually to ON) or ACTIVE (if an action is in progress).
Circuit 01: PROG ú
Circuit light ok
Cir.1:08:00:00 06s ú
MTWTFS- Weekly 03/05 ok
Cir.1:08:05:00 EFF ú
MTWTFS- Weekly 03/05 ok
Cir.1:08:00:00 06s ú
MTWTFS- Weekly 03/05 ok
Circuit 12: START ú
Access control ok
Circuit 12:DELETE ú
Access control ok
Circuit 12: START ú
Access control ok
Circuit 12:STATUS ú
Access control ok