18
7.2.4 Access code
To enter or remove the master clock access code :
1/ Validate the option with the key.
The following screen is displayed :
2/ Choose the option you require and validate it with the
key.
The access code is xed, , , , .
If there are 3 attempts with the wrong access code, an alarm message appears. The keyboard is
locked for 10 minutes. It is possible to unlock it from the technician menu.
7.2.5 Time and date
To change the time or the date of the master clock :
1/ Validate the option with the key.
The following screen is displayed :
2/ You have access to the time zone selection.
The time zone selection allows you to automatically
manage winter/summer time changeovers.
If the zone is not available in the 20 pre-programmed towns
or time zones, select “PROG” mode which is programmed
in the technician menu.
3/ “PROG” mode allows you to congure personalised time zone differences and time
changeovers.
By default it is in “PROG” mode.
4/ The hour is ashing: set the hour using the and
keys and move on to the minutes with the key.
5/ Proceed in the same way for the date.
6/ Validate with the key. If the time has been changed, the seconds are reset to 0.
Access code ok
Time and date õ
Access code: Yes ú
ok
Time and date ok
Dynamic reception õ
Time zone : LONDON ú
(GMT + 00:00) ok
Time zone :PROG ú
(GMT) ok
Time 10:12:00 ú
Date 08/09/14 ok
To Next Page
Loading...
Need help?
General