BodyCAP e Celsius - Principles of Operation; Operating Principales; First Use; The Implementation of the Device

26
P073GUI001 - e-Celsius Medical Connect System User Manual.4 - EN
4. PRINCIPLES OF OPERATION
POWERING UP THE e-MED CONNECT WATCH
The e-Med Connect watch is delivered turned off. To take it out of shelf mode, you must turn on the system
by pressing and holding button 1 (on the edge of the BodyCAP side). This procedure turns on the screen
of the watch. If the screen does not light up, put the watch on charge and repeat the operation after a few
minutes. An LED indicates that the button has been pressed. Before using the e-Med Connect watch on
battery, you must ensure that its charge level is sucient. A symbol on the display shows the battery level.
CHARGING THE BATTERIES
If you plan to use the watch on battery power, please check its charge status. The USB cable compatible with
the e-Med Connect watch allows charging of the watch's internal battery when it is connected to a power
source (mains power supply or a switched-on computer). The watch charges even when it is turned off.
The e-Celsius Mobile application allows you to retrieve and display the data collected by the capsule/
watch system. To do this, you need a device with a minimum required conguration:
Tablet or smartphone with the following conguration:
- Android 8 or higher
- Bluetooth Low Energy 4.x or 5.x
- Access to the "Play Store
- 100MB available for the installation of the application
To install e-Celsius® Mobile please:
- launch the Android play store
- Search for the "e-Celsius Mobile" application from the "BodyCAP" company
- Before launching the application, please make sure that the options "bluetooth" & "location"
are activated
- When using the application for the rst time you must allow the application to "access the
position of the device".
FIRST USE
THE IMPLEMENTATION OF THE DEVICE
INSTALLATION OF e-CELSIUS MOBILE