37
P073GUI001 - e-Celsius Medical Connect System User Manual.4 - EN
* dissociate the mobile object and the watch (Bluetooth):
This action will remove the automatic BLE connection to the watch. The watch will no longer appear in
the list of available watches. You will have to go through the pairing process again to be able to reset the
communication with the watch.
* Reset the watch:
Resetting the watch will couple prole separation with deletion of data and markers from the
memory of the watch.
This action is only possible if the watch is connected to the application and no capsule is active.
TURNING OFF THE e-MED CONNECT PRODUCT
It is possible to turn off the watch using the e-Celsius Mobile application. To do this, simply go to
the parameters of the watch (see paragraph above) and press the corresponding button.
The watch must be connected to the application. Once the order is sent, the watch displays a message of
extinction and it will shut down after a few seconds.
UPDATING THE WATCH
It is possible to update your e-Med Connect watch if a new software version has been provided by BodyCAP.
To do so, please go to the available settings on e-Celsius Mobile for the concerned e-Med Connect watch.
The e-Celsius Mobile application must recognize the BLE connection with e-Med Connect. Select "Update
watch" and follow the steps.
VISUALIZATION OF THE e-CELSIUS MEDICAL ALARM SYSTEM
Caregivers should regularly check the temperature displayed on the application screen e-Celsius Mobile
and the LED on the watch to identify alarms.
The watch associates 6 categories of alarms, 5 of them relate to the state of the electro-medical system
and 1 relating to the physiological state of the person.
The triggering and warning conditions for each alarm are summarized in the table below.
To Next Page
Loading...