08
1. INTRODUCTION
Congratulation for the choice of an BORRI Industrial Power Solutions product for the
safety of your devices. To use at the best the performances of your B8000 UPS we
suggest you to read with attention the present manual.
The scope of this manual is to describe briefly the parts that constitute the UPS and
to guide the installer and the user to the correct installation of the system in the chosen
room.
The installer and the user will have to read this manual with care and attention and
correctly carry-out the instructions provided, especially those relevant to security
according to the country standards in force.
WARNING
THE UPS CAN BE INSTALLED BY QUALIFIED PERSONNEL ONLY. THE UPS CAN
BE OPERATED BY EXPERIENCED PERSONNEL.
1.1 ENVIRONMENT
1.1.1 Packing
UPS packing materials must be recycled in compliance with all applicable
regulations.
1.1.2 Lead battery
This product contains lead-acid batteries. Lead is a dangerous substance for the
environment if it is not correctly recycled by specialised companies.
1.1.3 Treatment of UPS at the end of life cycle
For the UPS disposal at the end of its life cycle and for the recycling of the materials,
it’s strongly recommended to follow the regulations in force in the country of installation.
1.2 SAFETY RULES
1.2.1 Safety of persons
The UPS must be installed in a room with restricted access (qualified personnel only,
according to standard EN62040-1-2).
A UPS has its own internal power source (the battery). Consequently, the power
outlets may be energised even if the UPS is disconnected from the AC-power source.
To Next Page
Loading...
Need help?
General