Security Functions
3–6
1070 073 822-104 (02.06) GB
Configuration
This dialogue defines the start and runtime characteristics of UPS
monitoring.
To allow possible changes to take effect, the UPS program must be stopped
and restarted.
COM Port
The UPS program is always connected to the UPS via the COM4 serial port.
UPS Shutdown Parameter
Brute Shutdown
Upon receipt of the shutdown signal from the UPS, the shutdown command
for the Windows operating system is issued without delay. This causes the
immediate termination of all active aplications, followed by the shutdown of
Windows.
Smart Shutdown
Upon receipt of the shutdown signal from the UPS, the preset Delay Time
starts to elapse.
To Next Page
Loading...
