Bosch Rexroth IPC - BIOS Settings for IPC; BIOS Settings for IPC300

Maintenance and Replacement
8–14
1070 073 822-104 (02.06) GB
8.3.2 BIOS settings for IPC
. IRQ 3, 4, 5, 7, 10, 11, 14 are already occupied, and are therefore no
longer available for PCI and ISA expansion cards!
PCI slot
In the PCI/Plug and Play Setup BIOS menu you can assign an IRQ address
to each PCI expansion slot. The number of the IRQ address also defines the
priority.
If only PnP cards are used, the AUTO setting must be selected.
BIOS selection: PCI Slot1 IRQ Priority, PCI Slot2 IRQ Priority, PCI Slot3
IRQ Priority, PCI Slot4 IRQ Priority: AUTO, 3, 4, 5, 7, 9, 10, 11, 12
Default: AUTO
ISA slot (IRQ)
The IRQ address for non-PnP compatible ISA bus cards (so-called legacy
ISA cards) must be permanently set in the PCI/Plug and Play Setup BIOS
menu.
BIOS selection: IRQ3, IRQ4, IRQ5, IRQ7, IRQ9, IRQ10, IRQ11, IRQ14,
IRQ15: PCI/PnP, ISA/EISA
Default: PCI/PnP
ISA slot (DMA)
The PCI/Plug and Play Setup BIOS menu provides for the permanent
selection of a DMA channel for Legacy ISA cards.
BIOS selection: DMA Channel 0, DMA Channel 1, DMA Channel 2 , DMA
Channel 3, DMA Channel 4, DMA Channel 5, DMA Channel 6, DMA Chan-
nel 7: PnP, ISA/EISA
Default: PnP
. When using the PCL Software PLC, the use of DMA channels may pre-
vent real-time generation.
8.3.3 BIOS settings for IPC300
. IRQ 3, 4, 5, 7, 10, 11, 14 are already occupied, and are therefore no
longer available for PCI and ISA expansion cards!
PCI slot
You can use the The Advanced Menu / PCI Configuration sub menu
BIOS submenu to assign an IRQ address to each PCI slot. At the same time,
the number of the IRQ also defines a priority.
If only PnP cards are used, the AUTO setting must be selected.
BIOS select.: PCI
IRQ line 1, PCI IRQ line 2, PCI IRQ line 3, PCI IRQ line 4
Option: Disabled, Auto, IRQ: 3, 4, 5, 7, 9, 10, 11, 12, 14, 15,
Default: AUTO