Maintenance and Replacement
8–8
1070 073 822-104 (02.06) GB
9. If you have installed another type (e.g. 3.5” HD 2.88 MB), this must be
declared to the IPC BIOS. To access the BIOS menu, press the following
keys while the system is booting up::
D IPC: Press <del> .
D IPC300: Press the <F2> function key.
IPC: Go to the Standard SETUP menu option, and select the new floppy
disk type. Exit the BIOS via the Save Settings and Exit option (save hard
disk parameters).
To do this, press the <Y> button (= Yes).
IPC300: Go to the main menu, and select Diskette 1. Select the new
floppy disk type. Select Exit Saving Changes (saving new parameter
settings) to exit the BIOS menu.
10.If the floppy disk drive cannot be accessed, check for:
D Proper connection between controller cable and flopps disk drive.
D Proper seating of all cables and connectors.
D Presence of operating power.
To Next Page
Loading...
