Bosch Access Modular Controller 2 Installation Manual

Access Modular Controller 2 Table of contents | en 3
Bosch Security Systems B.V.
Installation manual
2021-04 | V04 | IM
Table of contents
1
Safety 5
1.1 Unpacking 6
1.2 FCC compliance 6
2
Short information 7
3
Introduction 8
3.1 Description 8
3.2 Product overview 10
3.2.1 Mainboard 10
3.2.2 Status display 12
3.3 System overview 14
4
Installing 15
4.1 Mounting the device on a mounting rail 15
4.2 Unmounting the device from a mounting rail 15
4.3 Opening the case 16
4.4 Closing the case 17
4.5 Cabling 18
4.5.1 Conductor data for powering the controller 18
4.6 Grounding and shielding 19
4.6.1 Grounding for Host Interface 19
4.6.2 Gounding for Extension Interface 20
4.7 Connecting the power supply to the controller 21
4.8 Ethernet host interface 22
4.9 RS-485 host interface 23
4.9.1 RS-485 Two Wire Connection 24
4.9.2 RS-485 Four Wire Connection 24
4.9.3 DIP switch selector 24
4.10 RS-485 for extension modules 26
4.11 Wiegand interface for card readers 27
4.12 Connecting relay outputs 28
4.13 Connecting analog input devices 30
4.14 Tamper protection 32
5
Operating 33
5.1 Configuring Ethernet interface 33
6
UL requirements 34
6.1 System requirements 35
6.1.1 Computer 35
6.2 UL 294 level descriptions 35
6.3 Installation instructions 35
6.4 Extended technical specification 38
6.4.1 RS-485 extension 38
6.4.2 Power consumption 38
7
Troubleshooting 39
7.1 Resetting the software 40
7.2 Resetting the device to factory default 41
8
Service and repair 42
9
Disposal 43
10
Technical specifications 44
11
Appendices 46

Bosch Access Modular Controller 2 Specifications

General

Brand	Bosch
Model	Access Modular Controller 2
Category	Controller
Language	English