Bosch AMC-4W - Installing the AMC-4 W; Mounting the AMC-4 W

Access Controller AMC-4W Installing the AMC-4W
Bosch Security Systems | V.3.1/2006-09 Installation Guide 21
5. Installing the AMC-4W
5.1. Mounting the AMC-4W
5.1.1. Mounting on rails
The AMC-4W can be attached on a standard 35 mm mounting rail via a snap-in
mechanism. Attach the AMC-4W into the lower edge of the mounting rail, the
lift the AMC-4W and snap it onto the rail by pushing it towards the back.
Figure 7: Mounting the AMC-4W on a mounting rail
5.1.2. Demounting the AMC-4W from mounting rails
To remove the AMC-4W from a mounting rail, first, remove all pluggable
screw connectors. Lift up the AMC-4W until it snaps out of the mounting rail.
Pull the upper end of the AMC-4W from the mounting rail.
Figure 8: Demounting the AMC-4W from a mounting rail