Bosch AMC-4W - Figure 31: Restarting the AMC-4 W with the Provided Screw Driver; Figure 32: Resetting the AMC-4 W to Delivery State

Access Controller AMC-4W Operating the AMC-4W
Bosch Security Systems | V.3.1/2006-09 Installation Guide 43
Resetting the network configurations (figure32):
1. Reset the AMC as described above (in download program)
2. Open the upper case of the AMC-4W
3. Set all six DIL switches of the RS485 selector to ON
4. Press the tamper switch on the upper left side of the board
5. The AMC-4W will now have the following network configuration:
a. DHCP = 0
b. IP = 127.0.0.1
Figure 31: Restarting the AMC-4W with the provided screw driver
Figure 32: Resetting the AMC-4W to delivery state