Bosch AVIOTEC 8000i IR - Installation; Requirements

AVIOTEC 8000i IR Installation | en 25
Bosch Sicherheitssysteme GmbH
User manual
2023.10 | 02 | F.01U.414.168
4 Installation
i
Notice!
Qualified personnel only.
Assembly and installation must only be performed by qualified personnel.
i
Notice!
Avoid backlight.
Backlight can disturb the video-based fire detection algorithm.
i
Notice!
Avoid image regions with continuous upward motion.
Continuous upward motion might lead to false alarms.
i
Notice!
Do not expose the image sensors to direct sunlight.
Do not obstruct the free flow of air around the camera.
i
Notice!
Minimum Illumination required.
To enable the proper functioning of the video-based fire detection algorithm, a minimal
illumination of 1 lx is required. If the illumination is less than 1 lx, the internal or additional
IR illumination is required.
i
Notice!
Avoid obstructions in the field of view!
Covered fires cannot be detected correctly. An unobstructed view of the detection area is
necessary.
i
Notice!
Make sure the camera is firmly mounted.
Camera shake might lead to non-detection. Avoid vibrations of the camera and the camera
environment.
4.1 Requirements
When installing the camera, take the following points into account or have prepared the
following:
– Computer and its IP address
– Download of newest Firmware / Software tools
– IP range of the network
– Plan sketches with camera position and designation
– Planning of the camera setting (size flame/ smoke, verification time + sensitivity if
available)
– Recording
– Required work equipment for configuration:
– POE power supply + camera connection
– Computer with admin rights and Internet access