Bosch AVIOTEC 8000i IR - 10-Pin I;O Connector; Alarm and Trouble Output

28 en | Installation AVIOTEC 8000i IR
2023.10 | 02 | F.01U.414.168
User manual
Bosch Sicherheitssysteme GmbH
– Use STP Category 5e (or higher) cable with punch down connector.
Note: If needed, test the cable by putting the network cable tester in the RJ45 port.
– Power can be supplied to the camera via the Ethernet cable compliant with the Power-
over-Ethernet standard and/or via the 24VAC / 12-26VDC auxiliary power.
i
Notice!
Use only PoE approved devices.
Power-over-Ethernet (PoE) can be connected at the same time as a 24VAC / 12-26VDC
power supply. If auxiliary power (24VAC / 12-26VDC) and PoE is applied simultaneously,
the camera draws its power from PoE by default, and seamlessly switches to auxiliary input
if PoE power fails.
When PoE power returns, the camera seamlessly switches back to PoE as its default power
source.
6
8
2
4
7
1
3
5
4.5.1.1 8-pin T568A
Pin T568A
1 White/Green
2 Green
3 White/Orange
4 Blue
5 White/Blue
6 Orange
7 White/Brown
8 Brown
4.6 10-pin I/O connector
4.6.1 Alarm and Trouble output
The alarm contact assignment is shown in the figure below: