Bosch AVIOTEC 8000i IR - Network and PoE power - RJ45

AVIOTEC 8000i IR Installation | en 27
Bosch Sicherheitssysteme GmbH
User manual
2023.10 | 02 | F.01U.414.168
2. Use STP Category 5e cable with RJ45 connectors (the camera network socket is Auto
MDIX compliant).
ð The LEDs beside the Ethernet connection indicate network connection (green lit) and
IP traffic (orange flashing).
The camera can be supplied with a power supply in case of missing PoE feature of the
network or for redundancy reasons.
Connect an approved power supply unit with a rated supply voltage of 12-26VDC/24 VAC
as follows:
1. Strip back 7mm (0.28in) of insulation on the power supply cable (must be 16-28AWG,
UL 14-30 AWG).
2. Loosen the screws of the supplied 2-pole connector and insert the stripped wires, then
tighten the screws again.
3. Insert the 2-pole connector into the camera power socket.
!
Caution!
The Low Voltage power supply unit must comply with EN/UL 60950. The power supply must
be a SELV-LPS unit or a SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power
Source).
i
Notice!
Make sure to pull and hold the safety plunger when removing the camera.
1
2
4
3
6
7
8
5
1 10-pin I/O connector 2 Safety wire anchor
3 Grommet (IP66 or IP67) 4 Punch down network connector
5 RJ45 network connector 6 Cable holder / grounding point for
punch down connector
7 Safety plunger 8 PCBA camera connector
4.5.1 Network and PoE power - RJ45
Connect the camera to a 10/100 Base-T network: