Bosch AVIOTEC 8000i IR - Adaptation to the lighting situation

AVIOTEC 8000i IR Adjustment of detection settings | en 45
Bosch Sicherheitssysteme GmbH
User manual
2023.10 | 02 | F.01U.414.168
for each mask: 4 ... 120 . A clock icon with a small smoke plume is displayed at the
bottom right-hand corner.
Verification time flames
The following settings (in seconds) are possible to assign an individual verification time
for each mask: 4 ... 120. A clock icon with a small flame is displayed at the bottom
right-hand corner.
2. Change the size and shape of the rectangle to your specific needs.
3. Move the mask to the desired area in the picture.
4. Select Set to confirm the changes.
Masking
Due to the different areas of application of the camera, false alarms may be the result in
individual customer environments. Algorithm disturbing elements which have an appearance
similar to flames and smoke, for example ascending steam of a machine, may trigger false
alarms and should be avoided in the detection area.
Customized areas can be defined in the picture of the camera. These individual masks for
flame and smoke detection deactivation allow individual adaption to the application of the
customer. Overlapping of masks is possible.
There are several possibilities to exclude picture areas from the smoke and flame detection:
– Add masks separately for flame, smoke or both.
– Individually adjust the verification time in a mask.
i
Notice!
There is no fire detection in privacy defined masks.
Reset user interface
i
Notice!
All determined masks in the user interface will be deleted!
If you want to reset the user interface to standard values:
1. Click on Defaults.
2. Press OK to confirm.
ð The system resets the user interface for fire detection to the standard settings.
7.3 Adaptation to the lighting situation
i
Notice!
In standard mode, there are no settings in the Configuration Manager regarding image
processing except white balance and ALC mode.