Flexible Automation
System modules
5-1
1070 072 143-101
5 System modules
CAUTION 5.1
Danger to the module!
Do not insert or remove the module when the control is switched on!
This can destroy the module. Switch off or remove the power supply
module of the control, external power supply and signal voltage before
inserting or removing the module!
CAUTION 5.2
Danger to the module!
All ESD protection measures must be observed when using the mo
dule! Avoid electrostatic discharges!
The Bosch control system CL400 is a PLC system that facilitates the use of
system modules with its own processor.
The following system modules are available for special applications:
D ZAT1/2 and ZAT1/10
D ZAT2/2 and ZAT2/10
D Computer interface module R500
D Computer interface module R500P
D Diagnostic module DB500
The advantages of the system modules lie in the largely independent work
ing method of the central processing unit ZS400 and other system mod
ules. They relieve the central processing unit ZS400, and the execution of
parallel processes shortens the reaction and cycle times.
To Next Page
Loading...
