18/176 Introduction
Bosch Rexroth AG, MIT: ID 40, 3 842 530 344/2014-05
2.2.2 Status display
The 4-character status display of the ID 40/SLK shows the operating states of the
SLK, error messages and the status of the fieldbus interface. After the SLK is turned
on, the currently configured fieldbus address (node no. depending on fieldbus
system) appears on the display for a few seconds.
While running, the display is divided into two areas: Area 1 contains the first three
segments on the left, and area 2 the first segment on the right.
Area 1 Area 2
Fig. 4: ID 40/SLK read/write head status display
Area 1 shows the operating state of the SLK or an error code in the event of an error.
Area 2 shows when the SLK is ready as well as the status of the fieldbus connection
to the user controller.
In the Interbus version, area 2 is divided differently, see Chapter 11.2.4 “Interbus
status display”.
PROOF COPY 1 | 20.05.2014 | FOR INTERNAL USE ONLY
To Next Page
Loading...
