IndraControl L40 Technical Data 4-3
DOK-CONTRL-IC*L40*****-PR02-EN-P
Refraining from a blower may be considered if all of the following
conditions are fulfilled:
• Ambient temperature < 45 °C
• Load applied to the 7.5-V Inline supply (U
L
) < 1 A
• Load caused by the onboard outputs < 1 A
• Load caused by the function modules < 10 W (table in preparation).
4.4 Used Standards
The IndraControl L40 complies with the following standards:
Standard Description
DIN EN 60 204-1 Electrical equipment of machines
DIN EN 50 081-2 Special basic standard for emitted interference
DIN EN 61 000-6-2 Special basic standard for noise immunity
DIN EN 61 131-2 Programmable controllers
Equipment requirements and tests
DIN EN 60 529 Degrees of protection (incl. housings and installation
compartments)
DIN EN 50 178 Electronic equipment for use in power installations
UL 508 Industrial Control Equipment
Fig. 4-4: Used standards
Note: The IndraControl L40 complies with CE requirements!
4.5 Compatibility Test
All Rexroth controls and drives are developed and tested according to the
latest state-of-the-art.
As it is impossible to follow the continuing development of all materials
(e.g. lubricants in machine tools) which may interact with our controls and
drives, it cannot be completely ruled out that any reactions with the
materials used by Bosch Rexroth might occur.
For that reason, test new lubricants, cleaning agents, etc. for compatibility
with our housings / our housing materials before using the particular
material concerned.
IAS COMPONENTS www.ias-components.com info@ias-components.com
To Next Page
Loading...
