8-18 Installation and Maintenance IndraControl L40
DOK-CONTRL-IC*L40*****-PR02-EN-P
• Put a screwdriver into the actuation slot of the appropriate terminal
point (Fig. 8-12 , A) as far as necessary to be able to insert the core
into the opening of the spring.
• Insert the core (Fig. 8-12, B). Pull the screwdriver out of the opening.
This fixes the core.
Please refer to the pertinent module-specific data sheet for information on
the connector pin assignment .
• Open the shield connector (3).
• Check the orientation of the shield clip in the shield connector (see Fig.
8-13:).
• Place the line including surrounding braided screen in the shield
connector (4).
• Close the shield connector (5).
• Tighten the screws on the shield connector using a screwdriver (6).
1
1
1
2
1
3
1
4
1
5
1
6
a
Schirmschelle.FH9
Fig. 8-14: Orientation of the shield clip
The shield clip (a in Fig. 8-14, 2) in the shield connector can be used
according to the line cross-section. If thicker lines are used, the camber of
the clip must be directed away from the line (Fig. 8-14, 2). If thinner lines
are used, the camber of the clip must be directed towards the line (Fig. 8-
14, 6).
If you have to change the orientation of the shield clip, proceed as
described in Fig. 8-14:
• Open the housing of the shield connector (1).
• When delivered, the shield connector is intended for the connection of
thicker lines (2).
• Remove the clip (3), turn the clip according to the cross-section of the
line used (4), and fit the clip (5).
• Figure 6 illustrates the clip if a thin line is used.
Wiring the Connectors
Connecting the Shield
Shield Clip
IAS COMPONENTS www.ias-components.com info@ias-components.com
To Next Page
Loading...
