11-2 List of Figures IndraControl L40
DOK-CONTRL-IC*L40*****-PR02-EN-P
Fig. 8-2: Latching on a module 8-4
Fig. 8-3: Removing a module 8-5
Fig. 8-4: Fuse replacement 8-6
Fig. 8-5: Setup without electrical isolation 8-8
Fig. 8-6: Setup with electrical isolation 8-9
Fig. 8-7: Reference conductor connected to the protective conductor 8-10
Fig. 8-8: Reference conductor not connected to the protective conductor
8-11
Fig. 8-9: Overview: Shield connection of analog sensors and actuators
8-14
Fig. 8-10: Connection of analog sensors in case of signal lines > 10 m
8-14
Fig. 8-11: Connection of actuators, in case of signal lines > 10 m 8-15
Fig. 8-12: Connecting lines to the tension spring connectors 8-16
Fig. 8-13: Connecting the shield to the shield connector 8-17
Fig. 8-14: Orientation of the shield clip 8-18
Fig. 9-1: Basic structure of a Rexroth Inline modules 9-1
Fig. 9-2: Rexroth Inline connector types 9-2
Fig. 9-3: Color-coding of the terminal points 9-3
Fig. 9-4: Connector design 9-3
Fig. 9-5: Connector coding 9-4
Fig. 9-6: Identification of function 9-5
Fig. 9-7: Color coding of modules 9-5
Fig. 9-8: Numbering of terminal points 9-6
Fig. 9-9: Labeling of modules 9-7
Fig. 9-10: Dimensions of the electronic sockets (2-slot housing) 9-8
Fig. 9-11: Dimensions of the electronic sockets (4-slot housing) 9-9
Fig. 9-12: Dimensions of the electronic sockets (8-slot housing) 9-9
Fig. 9-13: Connector dimensions 9-10
Fig. 9-14: Voltage and data routing 9-11
Fig. 9-15: Voltage jumpers (see Fig. 9-14) 9-11
Fig. 9-16: Data jumpers (see Fig. 9-14) 9-12
Fig. 9-17: Meaning of the "STOP" LED (see chapter "Reset Button and
Light-Emitting Diode" on page 6-2) 9-13
Fig. 9-18: Meaning of the "Send" LED (see chapter "PROFIBUS DP" on
page 7-13) 9-13
Fig. 9-19: Meaning of the "Dist." LED Distortion indicator for SERCOS
interface (see chapter "SERCOS" on page 7-14) 9-13
Fig. 9-20: Meaning of the "Ready" LED (see chapter "Ready contact" on
page 7-14) 9-14
Fig. 9-21: Diagnostic LED of the power terminal 9-14
Fig. 9-22: Diagnostic LED of the segment terminal 9-14
Fig. 9-23: Diagnostic LED of the supply voltage 9-14
Fig. 9-24: "FS" and "FN" LEDs 9-14
Fig. 9-25: Status LEDs of input/output terminals 9-14
IAS COMPONENTS www.ias-components.com info@ias-components.com
To Next Page
Loading...
