Remote Arming by Telephone
This feature allows you to arm your system from any remote location by telephone. For
obvious security reasons, you cannot disarm the system using this method. A touch-tone
telephone is required to use this feature.
To remotely arm your system by telephone:
1. Call the telephone number to which your control panel is connected. When the control
panel answers the incoming call, a short jingle sounds.
– If you hear modem tones (a high tone and a low tone) when the control panel
answers the incoming call, the system is programmed for remote arming by
telephone. Wait for a pause in the tones and follow Step 2 to arm the system
remotely.
2. Press [*] on the touch-tone telephone to arm the system. Two beeps sound to indicate
that the system is armed in AWAY Mode.
3. Hang up the telephone. The system remains armed.
If the control panel does not answer the call, the ring count might be set to 0. If the control
panel answers the call without modem tones, remote arming by telephone might not be
enabled. To enable remote arming by telephone, select Option 2 in Location 177 (refer to
Communication Options 1, page 77). To set the number of rings before the control panel
answers, refer to Ring Count, page 75.
Notice!
Using this method with a partitioned control panel arms both areas in AWAY Mode. Arming
individual areas is not available with this method.
9
60 en | Remote Arming by Telephone Control Panel
2017.10 | 03 | F.01U.298.026 Installation Guide Bosch Security Systems, Inc.
To Next Page
Loading...
Need help?
General
