Solution 6000
28 Bosch Security Systems 12/14 BLCC610U
User Guide
Outputs > Properties >
Output Name
MENU 4-1-0
This menu allows you to program the name for each output.
Each output name supports up to 20 characters.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [1] + [0].
A list of available outputs will display on the keypad.
2. Use the [] and [] keys to select the output name
that you want to change, then press [OK] to select.
Alternatively, you can enter the output number,
then press [OK].
The keypad will display the following:
Output Name Op1
External Siren
Press
OK to SAVE
3. Use the [] and [] keys to scroll the cursor left and
right across the output name text. Use the [] and
[] keys to scroll through the dierent characters
available. To clear all text from the cursor position
to the right, press the [OFF] key.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Outputs > Door Control >
Door Name
MENU 4-2-0
This menu allows you to program the name for each door
on the system. Each door name can be up to 20 characters
long.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [2] + [0].
A list of available doors will display on the keypad.
2. Use the [] and [] keys to select the door name
that you want to change, then press [OK] to select.
Alternatively, you can enter the door number, then
press [OK].
The keypad will display the following:
Door Name Dr3
Door 3 Name
Press
OK to SAVE
3. Use the [] and [] keys to scroll the cursor left and
right across the door name text. Use the [] and
[] keys to scroll through the dierent characters
available. To clear all text from the cursor position
to the right, press the [OFF] key.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Outputs > Output Testing >
External Siren Test
MENU 4-9-0
This menu allows you to test any external sirens which
have been connected by your installer. The test will last for
5 seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [0].
If the system has multiple areas, the keypad will
display a list of areas.
A1 Security System
A2 Area 2 Name
A3 Area 3 Name
Press
OK or MENU
2. Use the [] and [] keys to select the area that you
want to test the external sirens in, then press [OK].
Alternatively, you can enter the area number, then
press [OK].
The keypad will display the following during the
siren test.
External Audible Testing
Press any key to abort
Press OK or MENU
When the siren test is complete, the keypad will
display the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Outputs > Output Testing >
Internal Siren Test
MENU 4-9-1
This menu allows you to test any internal sirens which have
been connected by your installer. The test will last for 5
seconds.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [9] + [1].
If the system has multiple areas, the keypad will
display a list of areas.
A1 Security System
A2 Area 2 Name
A3 Area 3 Name
Press
OK or MENU
2. Use the [] and [] keys to select the area that you
want to test the internal sirens in, then press [OK].
Alternatively, you can enter the area number, then
press [OK].
To Next Page
Loading...
Need help?
General
