Multi-DM™ User Manual Section 9 - DMShapes Software Overview
BMC Document Number: DOC-0009 Rev. 5.2 Page 31
Piston
Displays a scale and a slider and allows changes to the entire array of actuators. For
detailed information see Section 9.1.4, The DMShapes Piston.
Status Bar
Displays information on the last selected actuator and current piston setting. For detailed
information see Section 9.1.5, The DMShapes Status Bar.
9.1.1 The DMShapes Menu Bar
The DMShapes Menu Bar contains the following commands.
File > Open DM Loads a user selected Profile file
File > Open Driver Map This command is not used
Loads a user selected Calibration file
Used with open loop calibration only
File > Save Shape As... Saves the current shape settings to a user selected file name
Note that Administrator permissions are required
to save this file to the Shapes folder.
Shows or hides a grid pattern separating the actuators
Options > Apply Offsets Applies the offsets defined in the current Calibration file
Used with open loop calibration only
Displays a dialog showing the program version
To Next Page
Loading...