Boston Multi-DM - Page 41

Multi-DM™ User Manual Section 9 - DMShapes Software Overview
BMC Document Number: DOC-0009 Rev. 5.2 Page 38
9.2.4 To Change All Actuators
• In the Piston Area, click and drag the slider to the desired value, then release.
As you move the slider:
o In the Actuator Map display, all actuators will change to the color for that value.
o In the Status Bar the Piston Value will update.
o The value will be immediately applied to the actuators on the DM.
9.2.5 To Set All Actuators to 0
• On the Toolbar, click the Zero button.
o In the Actuator Map display, all actuators will change to the color for 0 (blue).
o In the Status Bar the Piston Value will update to 0.00.
o The value will be immediately applied to the actuators on the DM.
9.2.6 To Change a Single Actuator
1. Click on the actuator.
In the Status Bar the Poke Actuator Value will update.
A spin box will display with the current value of the actuator shown.
2. In the spin box, set the desired value by doing one of the following:
• Click the up or down arrows.
• Enter the value on the keyboard.
As you change the value:
o In the Actuator Map, the display for that actuator will change
to the color for that value.
o In the Status Bar the Poke Value will update.
o The value will be immediately applied to that actuator on the DM.