BOYING PALADIN-V2 - Brief Operation Process; Precautions

To Next Page

To Previous Page

Flight control system user manual 󾗕Agriculture

1. Check whether the power supply and the connection cables between peripherals and 󽗊ight control

are correct;

2. The ground station starts, open the Boying ground station;

3. RC remote control device is turned on;

4. The aircraft system is powered on and linked to the ground station;

5. Calibrate the remote control. If it has been calibrated, skip this step;

6. Calibrate the ESC (do not install the propeller). If it has been calibrated, skip this step;

7. Turn on the motor test function of the ground station and ensure that the motor rotation and motor

serial number are consistent with the set rack type;

8. Calibrate the accelerometer. If it has been calibrated, skip this step;

9. Calibrate the magnetic compass. If it has been calibrated, skip this step;

10. Set 󽗊ight mode;

11. Set up failsafe;

12. Check whether there is a warning message on the ground station, analyze the cause and solve it;

13. Check whether the key data is normal, such as: attitude data, heading data, GPS data, move the body,

and observe whether the data changes are normal;

14. Check the GPS installation direction and whether it is secure;

15. Check the 󽗊ight control installation direction and shock absorption;

16. Check the motor rotation direction and propeller installation direction and whether the installation is

󽗉rm;

17. Turn the 󽗊ight mode switch and observe the 󽗊ight mode display area of the ground station to see if it

switches normally;

18. Set route tasks, upload and download to con󽗉rm the route planning is correct.

Brief operation process

Precautions

1. Be familiar with the 󽗊ight environment and stay away from obstacles, crowds, etc. when 󽗊ying;

2. Never 󽗊y when you are not in good spirits;

3. Do not 󽗊y after drinking alcohol or taking psychotropic drugs to avoid accidents caused by human

factors;

4. Flying is prohibited during thunderstorms and strong winds to avoid damage to electronic equipment

and 󽗊ight hazards;

5. It is recommended to wear sunglasses when 󽗊ying manually under strong light;

6. Keep away from high temperature heat sources to avoid damaging electronic components;

7. Beginners should 󽗊y under the guidance of an experienced pilot;

8. Prepare necessary tools before 󽗊ying, such as wrenches, screwdrivers, spare propellers, binoculars,

walkie-talkies, sunglasses, medical 󽗉rst aid kits, etc.;

9. Do not take o󽗈 or 󽗊y with overload to avoid damage to the aircraft structure and 󽗊ight hazards;

10. Stay away from high-speed rotating propellers and do not get close to them;

11. Before 󽗊ying, check whether the aircraft equipment is working properly. If the key equipment is not

working properly, do not force the aircraft to 󽗊y to avoid accidents.