Preparing the Clearway 2 for Use 26
DOC-001000 Ver 6 Clearway 2 User Manual .
Connecting to AC Power (Mains Power)
Read the chapter “Electrical Safety” on page 15 carefully to
make sure all conditions are considered and met.
AC Mains cable must be fitted with a 10 (A) amp fuse.
Always use the correct AC mains cable (part number 009074).
Ensure nothing is blocking the AC power cable that may cause
difficulty disconnecting the mains power.
Inspecting the Clearway 2 before Use
Inspection of device before use
• Check that there is no visible damage.
• Check that the surface is clean.
Inspection of Cables
• Check that all cables are recommended by Breas Medical Ltd. (see
“Accessories” page 78)
• Check that the cables are undamaged.
• Check that the cables are properly connected.
Inspection of Placement
• The Clearway 2 shall be placed on solid flat surface below the patient
level. (See “Placing the Clearway 2 Ready for Use” on page 25.)
• Make sure that nothing can block the air inlets on rear and side of the
device.
To Next Page
Loading...
Need help?
General
