Breas Clearway 2 - Cleaning the Clearway 2

Cleaning & Maintenance 58
DOC-001000 Ver 6 Clearway 2 User Manual .
Cleaning the Clearway 2
To avoid electrical shock, disconnect the mains supply to the
Clearway 2 before cleaning. Do not immerse the device into any
fluids.
• Always be careful when cleaning the ensure that you do not
damage any equipment.
• Fluid must not be allowed to enter the Clearway 2.
• Never apply any liquids directly on the Clearway 2 by spraying,
splashing, or pouring. Use a moistened lint-
free cloth when
cleaning.
•
Do not use an excessive amount of liquid when cleaning the
Clearway 2.
• Do not autoclave the Clearway 2.
General cleaning may be carried out by the lay operator in the
homecare environment.
Cleaning the Exterior of the Clearway 2 unit
1.
Turn off the Clearway 2 and disconnect the mains supply.
2. Remove the patient circuit.
3. Disconnect all electric cables.
4. Clean the outside of the Clearway 2 using disinfection wipes containing
ethanol 70%.
5. Reconnect the patient circuit. Make sure all parts are dry before the
Clearway 2 is put into operation.
Inspect the device, power cord and patient circuit for damage whilst cleaning.
If the is any damage noticed, do not continue to use the device, and contact
your care provider, hospital or referring clinician immediately.