BridgeWave FLEX4G-LITE - Product Description and Overview; FLEX4 G-LITE Description

Page 13 of 84
040-57105-01
2 Product Description and Overview
The FLEX4G-LITE product is designed to provide the network operator the flexibility of
providing first mile access, as well as backhaul, for gigabit Ethernet networks.
 “Plug & Play” simple installation and alignment
 Outdoor only capability/no Indoor unit
 10/100/1000BaseT Gigabit Ethernet Interface
 2xSFP Inputs
 Optional CPRI Interface with line rate options of 1, 2, 3 & 4
 Local Management Interface using CLI or HTML based web browser
 Remote management using SNMP v1,2 &3
 48 VDC Input (via either POE or direct using a two wire connection)
 Integrated & Direct slip-fit Antenna Mount options
 Low latency
 Frequency agile
FLEX4G-LITE Description
The FLEX4G-LITE millimeter wave radio is a point-to-point fixed wireless, ultra-high
capacity broadband access product operating in the upper millimeter wave spectrum
from 71-76 GHz and 81-86 GHz. The FLEX4G-LITE is capable of native Ethernet
payloads from 83 – 3000Mbps, full duplex. The radio system is designed for rapid
deployment.
In most locations, the FLEX4G-LITE will have a better than 99.995% link availability
at approximately 1 mile or 1.6Km. Actual path performance is dependent upon local
climate conditions. Please contact BridgeWave or your authorized representative for
additional information.
The FLEX4G-LITE is available in two model configurations. The FLEX4G-LITE-INT
model incorporates an integrated 38 dBi antenna (ETSI only). The Direct Mount
model (ANSI and ETSI) uses the custom slip-mount antenna interface for use with
1ft/30cm, 2ft/60cm and 3ft/90cm antennas.