2-3
Response: Controller returns to idle
mode.
Set Time:
Action: Press Cook Time Button twice
within 5 seconds.
Response: Programming mode has
been entered. Flashing Time Display
reads “##:##.” (##:## = time value ie:
08:00)
Action: If desired, press key pad num-
bers to change displayed value in min-
utes and seconds then press Cook
Time Button once to enter new value
into memory.
Response: Controller returns to idle
mode.
Reset Cycle Counter:
Action: Press Reset Button twice in 5
seconds.
Response: Display will return to a set-
ting of “00.”
If counter is not reset
before reaching “99.”
Upon the next cycle completion, the dis-
play will begin counting at “01.”
Normal operating programming can be
done at any time without affecting presets.
PRESET COOK MODE
Choose Preset Cook Cycle:
Action: Press a button, 0 thru 9, corre-
sponding to the desired preset.
Response: The TIME display will show
“P__X”, where X is the preset selected.
If a button is not pressed
in ten seconds, the display will revert to
the previous display.
Action: Press the same button again,
Response: The TIME display will show
the preset time, the TEMP display will
show the preset set point, and the
temperature will now regulate to the
new set point.
PROGRAMMING PROCEDURE (PRESET
MODE)
Action: Press and hold the TIME and
TEMP buttons simultaneously for three
seconds.
Response: The TIME display and
TEMP display will begin flashing. The
CYCLE COUNT display will show “-0”
indicating that the preset #0 values are
displayed. The preset values for the
TIME and TEMP will be shown on the
display.
Change Cook Time:
Action: Press the TIME button once.
Response: The TEMP display will turn
off and only the TIME display will flash.
Action: Key in the desired cook time
then press the TIME button to save the
new setting.
If a button is not pressed
in ten seconds, the dis-
play will revert back to both the TIME
and TEMP displays flashing.
broaster.com Manual #16501 8/06 Rev 10/20
To Next Page
Loading...
