Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 75
53-1002965-01
SSH debug commands
4
This command activates the SSH debugging.
Brocade# debug ip ssh
SSH: debugging is on
Brocade(config)#SSH: Incoming connection request received
SSH: ssh_get_free_session_id: ssh.client[0].in_use is 0
SSH: Client session (0) established
SSH: Outgoing connection is ready
ShtcpConnectionStatus[0]: connection established
SSH:ShtcpSend[0]: eSendComplete: the string length [24] !
ShtcpSendStatus[0]: eSendComplete
SSH: Outgoing connection is ready
SSH: Data is ready to receive
ShtcpReceiveStatus[0]: the string length [47]
SSH:ShtcpSend[0]: eSendComplete: the string length [216] !
ShtcpSendStatus[0]: eSendComplete
SSH: Outgoing connection is ready
SSH: Data is ready to receive
ShtcpReceiveStatus[0]: the string length [464]
SSH: Data is ready to receive
ShtcpReceiveStatus[0]: the string length [144]
SSH:ShtcpSend[0]: eSendComplete: the string length [640] !
SSH: Outgoing connection is ready
SSH: Data is ready to receive
SSH: Data is ready to receive
SSH: Remote closed connection
SSH: ssh_close_session#0, No. of Clients#0.
ShtcpReceiveStatus[0]: Closed
SSH: ShListen failed.
ShtcpOpenPassive[0]: WaitingForConnection
SSH: Incoming connection request received
SSH: ssh_get_free_session_id: ssh.client[0].in_use is 0
SSH: Client session (0) established
SSH: Outgoing connection is ready
SSH: Data is ready to receive
ShtcpConnectionStatus[0]: connection established
ShtcpReceiveStatus[0]: the string length [47]
SSH:ShtcpSend[0]: eSendComplete: the string length [24] !
ShtcpSendStatus[0]: eSendComplete
SSH:ShtcpSend[0]: eSendComplete: the string length [216] !
ShtcpSendStatus[0]: eSendComplete
SSH: Outgoing connection is ready
SSH: Data is ready to receive
ShtcpReceiveStatus[0]: the string length [464]
SSH: Outgoing connection is ready
SSH: Data is ready to receive
ShtcpReceiveStatus[0]: the string length [144]
To Next Page
Loading...
Need help?
General
