Brocade FastIron X Series Chassis Hardware Installation Guide 43
53-1001723-02
Installation precautions
2
Installation precautions
Follow these precautions when installing the chassis.
General precautions
All fiber-optic interfaces use Class 1 Lasers.
Do not install the device in an environment where the operating ambient temperature might
exceed 40 C (104 F).
Make sure the air flow around the front, sides, and back of the device is not restricted.
If you do not install a module in a slot, you must keep the slot panel in place. If you run the
chassis with an uncovered slot, the system will overheat.
Never leave tools inside the chassis.
To Next Page
Loading...
