Brocade Communications Systems FastIron X Series - About this Document; Audience; Supported Hardware and Software; Document Conventions

Brocade FastIron X Series Chassis Hardware Installation Guide ix
53-1001723-02
About This Document
Audience
This document is designed for system administrators with a working knowledge of Layer 2 and
Layer 3 switching and routing.
If you are using a Brocade Layer 3 Switch, you should be familiar with the following protocols if
applicable to your network – IP, RIP, OSPF, BGP, IGMP, PIM, DVMRP, and VRRP.
Supported hardware and software
The following hardware platforms are supported by this release of this guide:
• FastIron SuperX® (FSX)
• FastIron SX 800® (FSX 800)
• FastIron SX 1600® (FSX 1600)
• FastIron SX 1600-ANR® (FSX 1600-ANR) Layer 2 or Layer 3 switches
NOTE
This document describes software release 07.0.01b only. Refer to earlier releases of this guide for
information about software releases prior to 07.0.01b.
Document conventions
This section describes text formatting conventions and important notice formats used in this
document.