EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
Conguring a tunnel loopback port for a tunnel interface
NOTE
Conguring a tunnel loopback port for a tunnel interface is not applicable on ICX6610, FCX devices, and SX-FI-24GPP, SX-
FI48GPP, SX-FI-24HF, SX-FI-2XG, and SX-FI-8XG modules.
For details and important conguration considerations regarding tunnel loopback ports for GRE tunnels, refer to Tunnel loopback ports
for GRE tunnels on page 104 and Conguration considerations for tunnel loopback ports on page 107.
To congure a tunnel loopback port, enter commands such as the following:
device(config)# interface tunnel 1
device(config-tnif-1)# tunnel loopback 1/3/1
Syntax: [no] tunnel loopback unit / slot / port
The unit / slot / port parameter
identies the tunnel loopback port for the specied tunnel interface, for example 1/3/1.
Applying an ACL or PBR to a tunnel interface on a FastIron X Series module
To apply an ACL or PBR policy to a tunnel interface on a FastIron X Series module other than the SX-FI48GPP (48-port 10/100/1000
Mbps Ethernet POE interface module), enter commands such as the following:
Applying a PBR policy to a tunnel interface
device(config)# interface tunnel 1
device(config-tnif-1)# tunnel mode gre ip
device(config-tnif-1)# tunnel loopback 3
device(config-tnif-1)# interface ethernet 3
device(config-if-e1000-3)# ip policy route-map test-route
Applying an ACL policy to a tunnel interface
device(config)# interface tunnel 1
device(config-tnif-1)# tunnel mode gre ip
device(config-tnif-1)# tunnel loopback 3
device(config-tnif-1)# interface ethernet 3
device(config-if-e1000-3)# ip access-group 10 in
Applying an ACL or PBR to a tunnel interface on the SX-FI48GPP interface module
To apply an ACL or PBR policy to a tunnel interface on the SX-FI48GPP interface module, enter commands such as the following:
NOTE
Conguration of tunnel loopback ports are not applicable on the SX-FI48GPP interface
module.
Applying a PBR policy to a tunnel interface
device(config)# interface tunnel 1
device(config-tnif-1)# tunnel mode gre ip
device(config-tnif-1)# ip policy route-map test-route
IPv4 point-to-point GRE tunnels
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 111

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals