Brocade Communications Systems FastIron X Series User Manual

5. Enter the neighbor ipv6-address update-source command to specify an interface.
device(config-bgp-router)# neighbor fe80:4398:ab30:45de::1 update-source ethernet 1/3/1
6. Enter the address-family command and specify the ipv6 and unicast keywords to enter IPv6 address family conguration
mode.
device(config-bgp-router)# address-family ipv6 unicast
7. Enter the neighbor ipv6-address activate command to enable the exchange of information with the neighbor.
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 activate
8. Enter the neighbor ipv6-address route-map command and specify the out keyword to apply a route map to outgoing routes.
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 route-map out myroutemap
9. Enter the exit command until you return to global
conguration mode.
device(config-bgp-ipv6u)# exit
10. Enter the route-map name permit command to
dene the route map and enter route map conguration mode.
device(config)# route-map myroutemap permit 10
11. Enter the set ipv6 next-hop command and specify an IPv6 address to set the IPv6 address of the next hop.
device(config-routemap myroutemap)# set ipv6 next-hop 2001::10
The following example
congures a neighbor using a link-local address and congures a route map to set up a global next hop for
packets destined for the neighbor.
device# configure terminal
device(config)# router bgp
device(config-bgp-router)# local-as 1000
device(config-bgp-router)# neighbor fe80:4398:ab30:45de::1 remote-as 1001
device(config-bgp-router)# neighbor fe80:4398:ab30:45de::1 update-source ethernet 1/3/1
device(config-bgp-router)# address-family ipv6 unicast
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 activate
device(config-bgp-ipv6u)# neighbor fe80:4398:ab30:45de::1 route-map out myroutemap
device(config-bgp-ipv6u)# exit
device(config)# route-map myroutemap permit 10
device(config-route-mapmyroutemap)# set ipv6 next-hop 2001::10
Conguring BGP4+ peer groups
A peer group can be created and neighbor IPv6 addresses can be associated with the peer group. The peer group is then activated in the
IPv6 address family conguration mode.
1. Enter the congure terminal command to access global conguration mode.
device# configure terminal
2. Enter the router bgp command to enable BGP routing.
device(config)# router bgp
3. Enter the local-as command to
congure the autonomous system number (ASN) in which your device resides.
device(config-bgp-router)# local-as 1000
Conguring BGP4+
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 485

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English