About This Document
• Supported hardware and software..............................................................................................................................................................21
• What’s new in this document........................................................................................................................................................................21
• How command information is presented in this guide...................................................................................................................... 22
Supported hardware and software
This guide supports the following product families for FastIron release 08.0.30:
• FastIron X Series devices (chassis models):
– FastIron SX 800
– FastIron SX 1600
• Brocade FCX Series (FCX) Switch
• Brocade ICX
â„¢
6610 (ICX 6610) Switch
• Brocade ICX 6430 Series (ICX 6430)
• Brocade ICX 6450 Series (ICX 6450)
• Brocade ICX 6650 Series (ICX 6650)
• Brocade ICX 7250 Series (ICX 7250)
• Brocade ICX 7450 Series (ICX 7450)
• Brocade ICX 7750 Series (ICX 7750)
For information about the
specic models and modules supported in a product family, refer to the hardware installation guide for that
product family.
NOTE
The Brocade ICX 6430-C switch supports the same feature set as the Brocade ICX 6430 switch unless otherwise noted.
NOTE
The Brocade ICX 6450-C12-PD switch supports the same feature set as the Brocade ICX 6450 switch unless otherwise
noted.
What’s new in this document
The following table describes information added to this guide for FastIron software releases 08.0.30b.
TABLE 1 Summary of enhancements in FastIron release 08.0.30b
Feature Description Location
Updated content for defect x. Removed
unsupported sections.
The chapter BGP4 has been updated as part of a
defect x.
BGP4
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 21
To Next Page
Loading...
Need help?
General
