EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #210 background imageLoading...
Page #210 background image
Setting RIP timers
You can set basic update timers for the RIP protocol. The protocol must be enabled in order to set the timers. The timers command
species how often RIP update messages are sent.
To set the timers, enter the following commands.
device(config) router rip
device(config-rip-router)# timer 30 180 180 120
Syntax: [no] timers update-timer timeout-timer hold-down-timer garbage-collection-timer
The update-timer parameter sets the amount of time between RIP routing updates. The possible value ranges from 3 - 21845. The
default is 30 seconds.
The timeout-timer parameter sets the amount of time after which a route is considered unreachable. The possible value ranges from 9 -
65535. The default is 180 seconds.
The hold-down-timer parameter sets the amount of time during which information about other paths is ignored. The possible value
ranges from 0 - 65535. The default is 180 seconds.
The garbage-collection-timer sets the amount of time after which a route is removed from the rip routing table. The possible value
ranges from 0 - 65535. The default is 120 seconds.
Displaying RIP Information
To display RIP
lters, enter the following command at any CLI level.
device# show ip rip
RIP Summary
Default port 520
Administrative distance is 120
Updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Last broadcast 29, Next Update 27
Need trigger update 0, Next trigger broadcast 1
Minimum update interval 25, Max update Offset 5
Split horizon is on; poison reverse is off
Import metric 1
Prefix List, Inbound : block_223
Prefix List, Outbound : block_223
Route-map, Inbound : Not set
Route-map, Outbound : Not set
Redistribute: CONNECTED Metric : 0 Routemap : Not Set
No Neighbors are configured in RIP Neighbor Filter Table
Syntax: show ip rip
TABLE 50 CLI display of neighbor
lter information
Field. Deinition
RIP Summary area Shows the current conguration of RIP on the device.
Static metric Shows the static metric conguration. ".not dened" means the route map
has not been distributed.
OSPF metric Shows what OSPF route map has been applied.
Neighbor Filter Table area
Index The lter number. You assign this number when you congure the lter.
Displaying RIP Information
FastIron Ethernet Switch Layer 3 Routing
210 53-1003627-04

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals