EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #347 background imageLoading...
Page #347 background image
Maximum of Hop count to nodes: 0
Area 1:
Authentication: Not Configured
Interface attached to this area: eth 1/1/1
Number of Area scoped LSAs is 6
Sum of Area LSAs Checksum is 00046630
Statistics of Area 1:
SPF algorithm executed 3 times
SPF last updated: 302 sec ago
Current SPF node count: 3
Router: 2 Network: 1
Maximum of Hop count to nodes: 2
Global IPv6 Address used by Virtual Links in this area:10:1:1::2
Area 0.0.0.0 :
Authentication: Not Configured
Interface attached to this area: VLink 1
Number of Area scoped LSAs is 6
Sum of Area LSAs Checksum is 0002cc53
Statistics of Area 0.0.0.0:
SPF algorithm executed 3 times
SPF last updated: 302 sec ago
Current SPF node count: 2
Router: 2 Network: 0
Maximum of Hop count to nodes: 1
Syntax: show ipv6 ospf vrf vrf-name [area area-id | virtual-links]
Use the show ipv6 ospf vrf vrf-name neighbor command to display the currently selected neighbor for use by the Virtual Links in each
transit area.
device# show ipv6 ospf vrf red neighbor
Total number of neighbors in all states: 1
Number of neighbors in state Full : 1
Type tx rx tx-byte rx-byte
Unknown 0 0 0 0
Hello 32 32 1276 1280
DbDesc 2 2 116 116
LSReq 1 1 52 52
LSUpdate 2 2 184 200
LSAck 2 2 112 112
OSPF messages dropped,no authentication: 0
Neighbor: State: Full Address: 2001:db8:1::1 Interface: eth 1/1/1
OSPFv3 clear commands
The following OSPFv3 clear commands are supported.
Clearing all OSPFv3 data
You can use the clear ipv6 ospf all command to clear all OSPF data by disabling and enabling the OSPFv3 processes as shown in the
following.
device# clear ipv6 ospf all
Syntax: clear ipv6 ospf all
Clearing OSPFv3 data in a VRF
You can use the clear ipv6 ospf vrf command to clear anything in a
specic vrf as shown in the following.
device# clear ipv6 ospf vrf abc all
device# clear ipv6 ospf vrf abc traffic
OSPFv3 clear commands
FastIron Ethernet Switch Layer 3 Routing
53-1003627-04 347

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals