EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #564 background imageLoading...
Page #564 background image
2. Change the maximum number of routes, save the conguration, and reload the device.
device(config)# system-max ip-route-default-vrf 10000
Total max configured ipv4 routes are 12000
- Max ipv4 routes configured for default VRF are 10000
- Max ipv4 routes available for all non-default VRFs are 2000
Warning: Please revalidate these values to be valid for your configuration.
Reload required. Please write memory and then reload or power cycle.
device(config)#
device(config)# system-max ip-route-vrf 512
Reload required. Please write memory and then reload or power cycle.
device(config)#
device(config)# exit
device# write memory
Write startup-config done.
device# Flash Memory Write (8192 bytes per dot) .
Flash to Flash Done.
device# reload
Are you sure? (enter 'y' or 'n'): Rebooting(0)...
y
*
$
FCX Boot Code Version 7.3.03 (grz07303)
Enter 'a' to stop at memory test
Enter 'b' to stop at boot monitor
3. Conrm the modied values.
device(config)# show default values
sys log buffers:50 mac age time:300 sec telnet sessions:5
ip arp age:10 min bootp relay max hops:4 ip ttl:64 hops
ip addr per intf:24
:
:
System Parameters Default Maximum Current Configured
ip-arp 4000 64000 4000 4000
ip-static-arp 512 6000 512 512
pim-mcache 1024 4096 1024 1024
:
:
ip-route 12000 15168 12000 12000
ip-static-route 64 2048 64 64
:
:
ip-vrf 16 16 16 16
ip-route-default-vrf 12000 15168 10000 10000
ip6-route-default-vr 908 2884 908 908
ip-route-vrf 1024 15168 512 512
ip6-route-vrf 100 2884 100 100
device(config)#
Creating VLANs as links on a tagged port for security
Where Multi-VRF is used, for example, in an enterprise data center, trusted servers or devices should be allowed to communicate
directly, and untrusted ones should not be allowed to communicate directly at all. This optional task
congures tagged Layer 3 interfaces
to support secure VRF instances.
1. In global conguration mode, create a VLAN.
device(config)# vlan 10
device(config-vlan-10)#
2. Use the tagged command to identify the interface as secure.
device(config-vlan-10)# tagged e 1/1/1
Conguring Multi-VRF
FastIron Ethernet Switch Layer 3 Routing
564 53-1003627-04

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals