• Virtual neighbors
• IPsec
• key-add-remove interval
General OSPFv3 conguration information
To indicate whether the Brocade device is operating as ASBR or not, enter the following command at any CLI level.
device# show ipv6 ospf
OSPFv3 Process number 0 with Router ID 0xc0a862d5(192.168.98.213)
Running 0 days 2 hours 55 minutes 36 seconds
Number of AS scoped LSAs is 4
Sum of AS scoped LSAs Checksum is 18565
External LSA Limit is 250000
Database Overflow Interval is 10
Database Overflow State is NOT OVERFLOWED
Route calculation executed 15 times
Pending outgoing LSA count 0
Authentication key rollover interval 300 seconds
Number of areas in this router is 3
Router is operating as ABR
Router is operating as ASBR, Redistribute: CONNECTED RIP
High Priority Message Queue Full count: 0
Graceful restart helper is enabled, strict lsa checking is disabled
Nonstop Routing is disabled
The output of the show ipv6 ospf command indicates if the Brocade device is operating as ASBR. If the device is not operating as
ASBR, then there is no information about redistribution in the output.
Displaying OSPFv3 area information
To display global OSPFv3 area information for the device, enter the following command at any CLI level.
device# show ipv6 ospf area 400
Area 400:
Authentication: Not Configured
Active interface(s)attached to this area: None
Inactive interface(s)attached to this area: ve 20 ve 30
Number of Area scoped LSAs is 311
Sum of Area LSAs Checksum is 9e8fff
Statistics of Area 400:
SPF algorithm executed 10 times
SPF last updated: 5920 sec ago
Current SPF node count: 1
Router: 1 Network: 0
Maximum of Hop count to nodes: 0
Syntax: show ipv6 ospf area [area-id]
You can specify the area-id parameter in the following formats:
• As an IPv4 address, for example, 192.168.1.1.
• As a numerical value from 0 through 2,147,483,647.
The area-id parameter restricts the display to the
specied OSPF area.
TABLE 70
show ipv6 ospf area output descriptions
This eld Displays
Area The area number.
Interface attached to this area The device interfaces attached to the area.
Displaying OSPFv3 information
FastIron Ethernet Switch Layer 3 Routing
320 53-1003627-04