EasyManuals Logo

Brocade Communications Systems FastIron X Series User Manual

Brocade Communications Systems FastIron X Series
593 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #478 background imageLoading...
Page #478 background image
client-to-client-reflection Configure client to client route reflection
cluster-id Configure Route-Reflector Cluster-ID
community-filter Configure community list filters
compare-routerid Compare router-id for identical BGP paths
confederation Configure AS confederation parameters
dampening Enable route-flap dampening
default-information-originate
default-local-preference Configure default local preference value
default-metric Set metric of redistributed routes
distance Define an administrative distance
enforce-first-as Enforce the first AS for EBGP routes
fast-external-fallover Reset session if link to EBGP peer goes down
graceful-restart Enables the BGP graceful restart capability
local-as Configure local AS number
maximum-paths Forward packets over multiple paths
med-missing-as-worst Consider routes missing MED attribute as least
desirable
multipath Enable multipath for ibgp or ebgp neighbors only
neighbor Specify a neighbor router
network Specify a network to announce via BGP
next-hop-enable-default Enable default route for BGP next-hop lookup
next-hop-recursion Perform next-hop recursive lookup for BGP route
readvertise Allow readvertisement of best BGP routes not in
IP forwarding table
redistribute Redistribute information from another routing
protocol
table-map Map external entry attributes into routing table
timers Adjust routing timers
update-time Configure igp route update interval
IPv6 unicast address family
The IPv6 unicast address family
conguration level provides access to commands that allow you to congure BGP4+ unicast routes. The
commands that you enter at this level apply only to the IPv6 unicast address family.
BGP4+ supports the IPv6 address family conguration level.
You can generate a conguration for BGP4+ unicast routes that is separate and distinct from congurations for IPv4 unicast routes.
The commands that you can access while at the IPv6 unicast address family conguration level are also available at the IPv4 unicast
address family conguration levels. Each address family conguration level allows you to access commands that apply to that particular
address family only.
Where relevant, this chapter discusses and provides IPv6-unicast-specic examples. You must rst congure IPv6 unicast routing for
any IPv6 routing protocol to be active.
The following congurations are allowed under BGP IPv6 address family unicast mode:
device(config-bgp-ipv6u)# ?
Possible completions:
aggregate-address Configure BGP aggregate entries
always-propagate Allow readvertisement of best BGP routes not
in IP Forwarding table
bgp-redistribute-internal Allow redistribution of iBGP routes into IGPs
client-to-client-reflection Configure client to client route reflection
dampening Enable route-flap dampening
default-information-originate Originate Default Information
default-metric Set metric of redistributed routes
graceful-restart Enables the BGP graceful restart capability
maximum-paths Forward packets over multiple paths
multipath Enable multipath for ibgp or ebgp neighbors
only
neighbor Specify a neighbor router
IPv6 unicast address family
FastIron Ethernet Switch Layer 3 Routing
478 53-1003627-04

Table of Contents

Other manuals for Brocade Communications Systems FastIron X Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brocade Communications Systems FastIron X Series and is the answer not in the manual?

Brocade Communications Systems FastIron X Series Specifications

General IconGeneral
BrandBrocade Communications Systems
ModelFastIron X Series
CategorySwitch
LanguageEnglish

Related product manuals